BRAND NEW IN BOX kit of the
first Fiberglass Spitfires (Mk2s) ARF. This kit is complete and
100% Guaranteed Factory Fresh! This kit is 100% Scale to the real
plane.


This is a Brand New In Box, nitro gas powered, radio controlled,
Almost-Ready-to-Fly 90-108 SPITFIRE Fighter Airplane. It is designed for
intermediate or advanced modeler.
6-Channels Fighter Airplane ! Great collection for all fans !!!
- All-balsa construction keeps the plane lightweight, yet strong.

The Spitfire is a real beauty. Anyone who likes
the war birds is bound to love this airplane. The kit includes a fiberglass
fuselage, and is painted with in a dark brown and gray scheme.. The wings are
built up and covered with Solortex cloth covering and painted. All control
surfaces have beveled leading edges and the control horn mounts are
preinstalled. The leading edge of the wing is pre-shaped. Completely workable
flaps are also built into this kit. This kit can be fitted with either fix
landing gear or 90 degree rotating retracts.

The first
"unofficial" Spitfire was a total failure. Its designer, Reginald Mitchell named
the first prototype the "Shrew". His original design was a low cranked
monoplane with a fixed undercarriage, all metal with an open cockpit and 2
machine guns mounted in the forward fuselage sides and 2 wing mounted machine
guns, all synchronised to fire through the propeller arc. Designated the Type
224, it flew for the first time on 19 February 1934 in the hands of Vickers
Chief Test Pilot "Mutt" Summers. Originally designed to meet the Air Ministry's
demands for a new generation of fighter, the specifications were issued by the
Air Ministry in 1931, specification number F7/30 and was designed around the
open cockpit twin gunned aircraft of the day. The performance of this aircraft
was much lower than anticipated, the cooling system failed on a regular basis.
On this basis, Reginald Mitchell's designs were turned down.
Mitchell
persevered and developed his original plans further by designing the fighter
with thinner elliptical wings, a smaller span and a faired cockpit with a
perspex cover. This became the Type 300. With a new engine, the Rolls Royce
Merlin 27 litre PV-12 and the Air Ministry then issued a contract on 3 January
1935. By March of 1936 the prototype, K5054 completed its ground trials and so
was ready to go on its first flight. This prototype cost ?4,637 and flew for
the first time on 5 March 1936 which lasted just 8 minutes from 1635 hrs from
Eastleigh. "Mutt" Summers was the pilot and, when he landed, he told the ground
crew of "no problems" and "I don't want anything touched". The first official
Spitfire was born. This was derived from the Supermarine S6, (below) which won
the Schneider Trophy in 1934.




Engine Sold Seperately.
Kit Requires assembly. Can be flight-ready in 3-5 hours

The
first 77 Spitfires (Mk2s) had only a two bladed, fixed pitch propeller.
The remainder were three bladed, two position propellers. Fine pitch for
take off and course pitch for cruising. Later these were also fitted to
the earlier 77 Spits. The original flat canopy was replaced by the more
famous domed or bulged version to accommodate the taller pilot. Other
early improvements included armour plated windscreen and 6mm armoured
panels on the rear of the engine bulkhead, also behind the pilot. Guns
were found to freeze at high altitudes, therefore heating was also fitted
to the guns. Originally the armament was 8 Browning .303 machine guns but
in June 1939, 2 Hispano cannons were fitted to one Spitfire for trials.
But, as the wings were too flexible, this caused them to jam. Engineers
were tasked to solve this problem. The Hispano cannon being originally
designed to be body mounted. The closed cockpit also caused many pilots to
feel somewhat claustrophobic, being used to open cockpits, some leaving it
fully open! Also pilots were still unfamiliar with retracting
undercarriages, and accidents were caused by forgetting to lower the
undercarriage on landing.

Engine Sold Seperately.
Kit Requires assembly.
Can be flight-ready in 3-5 hours